Before it all began!

[Step 1] Starting with the removal of the shifter.

[Step 2] In 5 easy steps...

[Step 3] remove these 2 Leds

[Step 4] And off it goes!

Leaving this open

[Step 5] This must off

[Step 6] release here

[Step 7] and here

[Step 8] and finally this one..

[Step 9] and the unit is loose

[Step 10] and it looks like this inside

[Step 11] the cables behind...

[Step 12] to remove the silver-front you have to start with these two screwes...

[Step 13] steady..

[Step 14] release all the sides of the unit

[Step 15] pull out the unit...remember protection.

[Step 16] view inside

[Step 17] connectors

[Step 18] same connector

[Step 19] antenna plug

[Step 20] connectors detached

[Step 21] more wires

[Step 22] just release them

[Step 23] i am free...free i say :)

[Step 24] The speakercables (detailed description in "explained" page)

[Step 25] to remove the "doorinside" you need to take of this piece of rubber tape.

[Step 26] and unscrew this little devil

[Step 27] and behind here

[Step 28] unscrew this one

[Step 29] pull here

[Step 30] and things start to release

[Step 31] like this

[Step 32] remove the plastic triangle this way

[Step 33] all loose

[Step 34] The signal and speaker cables goes undere here.

[Step 35] remove the plastic by doing this

[Step 36] and this

[Step 37] lift this part

[Step 38] and your done

[Step 39] you also need to remove this cover

[Step 40] and all the rest on your way back to the amp

[Step 41] behind the backseats all these clips has to be removed. like this

[Step 42] then you can seperate the two parts

[Step 43] finished on one side

[Step 44] cargo room floor loose and ready for removal

[Step 45] starting with the powercable, maybe a closer look?

[Step 46] like this?

[Step 47] even closer

[Step 48] no water on my feet while driving...remember to seal the entrypoint.

[Step 49] inside car view (by the pedals)

[Step 50] another inside view

[Step 51] battery, positive, ground and fuse (with holder) mounted.

[Step 52] battery, positive, ground and fuse (with holder) mounted. full view

[Step 53] battery, positive, ground and fuse (with holder) mounted. third angle

[Step 54] speaker and signalcables are evolving

[Step 55] ready to solder

[Step 56] steady

[Step 57] go

[Step 58] all "behind silverconsole" soldering complete.

[Step 59] cable illustration

[Step 60] cable illustration

[Step 61] cable illustration

[Step 62] cable illustration

[Step 63] cable illustration

[Step 64] cable illustration

[Step 65] cable illustration (se the REM and GROUND wires hanging down)

[Step 66] chassi point for ground

[Step 67] pick up REM signal here. (amp will be on when ignition is on)

[Step 68] signal GROUND (thin black wire with blue connector)

[Step 69] aligning cables...tape is a nice tool

[Step 70] from chaos to...

[Step 71] perfection

[Step 72] connecting the amp with all the cables

[Step 73] this is how it looks right now (08.02.03)

[Step 74] First listen...look at that smile :)